Sub-station

voltage and current regulator how 41 403 09 ...

by:KEBO      2019-10-11
The AM102596 is a voltage regulator on the John Deere lawn tractor that features a singleKohler engine cylinder.The voltage regulator adjusts the current from the stator so that the battery charges with a smooth current that does not damage the battery.The test voltage regulator needs to know how to use a voltmeter.It takes 15 minutes to complete this program.
Park the machine on a hard level, set the parking brake and remove the key from the ignition.Raise the hood and find the voltage regulator on the right side of the engine.Bolted to the side of the engine is a small silver box.This is the regulator.
Disconnect the plug from the bottom of the voltage regulator.Turn on the voltmeter and set it to an ohm scale.Find the ground wire that holds the voltage regulator under the bolt on the engine block.Place the black lead from the voltmeter to the bolt with the ground wire below.Three spires were found under the regulator.
Place the red lead of the voltmeter to the prong farthest from the ground.Check reading.It should be number 31.2 M.If this is not a reading, the voltage regulator needs to be replaced.If it reads 31.2 M, move to the next step.
Keep the black lead on the ground and move the red lead to the middle.Check reading.Should be between 8 and 9 m.If this is not a reading, the voltage regulator needs to be replaced.If its reading is between 8 and 9 m, go to the next step.
Keep the black lead on the ground and move the red lead to the prong closest to the ground.Check reading.Should be between 8 and 9 m.If this is not a reading, the voltage regulator needs to be replaced.If all of these readings are within the specification range, the voltage regulator works fine.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...